SKU 65519
For technical questions, please call 1-800-444-3353.
Page 13
curely held on the spindle.
WArning: to prevent serious
injury, do not overtighten flange.
Overtightening can damage the
wheel, causing wheel failure.
installing a threaded Accessory
tO preVent
injurY:
Wear heavy-duty work gloves
when handling wire wheels
and brushes. these
accessories are sharp and
can cause injury.
Before installing an accessory, review
1.
the warnings on pages 4 - 7.
The accessory MUST be:
rated to at least 10,000 RPM,
•
no larger than 4-1/2” in diameter,
•
fitted with a threaded opening of
•
M14,
undamaged,
•
a sanding disc and backing pad, a
•
sanding flap disc, a wire wheel or
a wire cup brush (accessories not
included).
Press in and hold the Spindle Lock
2.
Button to prevent the Spindle from
turning.
Remove the Outer Flange and Inner
3.
Flange and keep in a safe place.
Thread disc accessory firmly onto
4.
the Spindle. Wrench tighten onto the
spindle.
Work piece and Work Area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
Secure loose work pieces using a
3.
vise or clamps (not included) to pre-
vent movement while working.
There must not be hazardous ob-
4.
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
You must use personal safety equip-
5.
ment including, but not limited to,
ANSI-approved eye and hearing pro-
tection, as well as heavy work gloves.
Before beginning work, provide for
6.
sparks and debris that will fly off the
work surface.
generAl OperAting
inStructiOnS
tO preVent
SeriOuS injurY:
Grip the tool firmly in both
hands.
Pull the Safety Switch (41) back, then
1.
squeeze the Paddle Trigger (43) to
start operation.
Allow the tool to come up to full
2.
speed before touching the work ma-
terial.
Apply the wheel to the work mate-
3.
rial, allowing the tool to operate at
full speed. If the tool bogs down, use
lighter pressure.
