Page 6
For technical questions, please call 1-800-444-3353.
SKU 66389
standards established by the area
power company.
Run wires from the panels, through
1.
weatherproof grommets and into
the enclosure where the charge
controller/regulator is located. Use
wires of the proper size and rating.
Connect to charge controller/regulator
2.
according to controller/regulator’s
instructions.
Secure all connections using
3.
terminals, or solder all wire splices to
ensure good connections.
Weatherproof all connections.
4.
SERvICING
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
TO PREvENT
SERIOuS INjuRY
FROM ELECTRIC ShOCk:
Before service, maintenance,
or cleaning:
dry solar panels and outdoor
a.
wiring thoroughly while
wearing electrically insulated
gloves.
Cover all solar panels with
b.
an opaque cover, such as a
blanket.
disconnect all solar panels.
c.
disconnect all batteries.
d.
TO PREvENT SERIOuS
INjuRY FROM ELECTRIC
ShOCk OR CuTS:
do not use damaged solar
panel. If wiring insulation
is damaged or weathered,
glass is cracked, or housing
is opened, have the problem
corrected before further use.
Note:
It is normal to see up to 20%
degradation in amorphous silicon
solar panel performance within the
first 6 months before the amorphous
coating stabilizes.
Cleaning
Clean and inspect the solar panel
system
MONThLY
, or more
frequently to maintain peak efficiency:
Wear electrically insulated gloves
1.
and ANSI-approved safety goggles.
Dry solar panels and outdoor wiring
thoroughly.
Cover all solar panels with an
2.
opaque cover, such as a blanket.
disconnect all solar panels and
3.
batteries.
Clean solar panels one at a time with
4.
mild, non-abrasive cleanser and soft
cloth and paper towels. Do not clean
with brushes or abrasive cleaners.
Inspect the general condition of the
5.
solar panel system (panels, batteries,
controllers, and mounting). Check
for loose hardware, wiring insulation
damage or weathering, cracked
glass, open housing, cracked or
broken parts, loose or corroded
contacts, and any other condition that
may affect its safe operation.
Inspect and maintain batteries
6.
according to supplier’s instructions.
