SKU 66745
For technical questions, please call 1-800-444-3353.
Page 6
Spray Nozzle if the Spray Gun is not
disconnected and depressurized.
Test spray on scrap material before
•
spraying work material. High pres-
sure spray may damage persons or
property.
Always use the Nozzle Tip Guard.
•
Never spray without the Guard in
place. Only use a Nozzle Tip speci-
fied by the manufacturer. Always
relieve pressure before removing
the Nozzle Tip to clean.
Do not leave the unit energized or
•
under pressure while unattended.
When the unit is not in use, turn off
the unit and relieve the pressure.
Always engage the Trigger Lock
•
when not spraying. Make sure the
Trigger Lock is functioning properly.
Make sure all connections are se-
•
cure before operating the unit.
Always check the Hose for damage.
•
Replace the Hose if damaged. Do
not kink or excessively bend the
Hose.
Route hoses and cables away from
•
traffic areas, sharp edges, moving
parts, and hot surfaces.
When in use, this sprayer must be
4.
plugged into a gFci (ground Fault
circuit interrupter) outlet properly
installed and grounded in
accordance with all codes and
ordinances.
Check with a qualified electrician if
you are in doubt as to whether the
outlet is properly grounded. If the
tool should electrically malfunction
or break down, grounding provides a
low resistance path to carry electricity
away from the user.
Never spray materials near fire,
5.
flames, electrical sparks, or any
other ignition source.
Never smoke
when spraying or in the vicinity of
spraying. Never smoke unless the
area has been thoroughly aired out.
Always provide good ventilation dur-
ing and after spraying to eliminate
any enclosed explosive atmosphere.
read and understand the instruc-
6.
tions and precautions provided by
the manufacturer of each paint/
solvent before using the sprayer.
Never spray the solvents listed below
in any Sprayer containing
aluminum
:
1, 1, 1-Trichloroethane
•
Methylene Chloride.
•
Halogenated hydrocarbons
•
Never spray the solvents mentioned
above in any Sprayer containing
aluminum
. Never use these solvents
for cleaning equipment. Never use
any solvent if in doubt of its composi-
tion or compatibility with aluminum,
other materials or this Airless Sprayer.
Such use can cause serious chemi-
cal reaction and equipment rupture,
resulting in property damage and/or
personal injury.
if used with only water-based ma-
7.
terials, do not spray or clean with
flammable liquids.
if used with only water-based or
8.
mineral spirit-type materials with a
minimum flash point of 69.8° Fahr
-
enheit, do not spray or clean with
liquids having a flash point less
than 69.8° Fahrenheit.
Paint or solvent flowing through
9.
the equipment is capable of pro-
ducing static electricity.
Static
