Page 20
for technical questions, please call 1-800-444-3353.
SKU 67561
Equipment Troubleshooting
problem
possible Causes
probable solutions
Engine Will Not Start
No fuel in tank.
1.
Engine Switch in OFF position.
2.
Fuel Valve turned OFF.
3.
Engine Oil level low.
4.
No spark at spark plug.
5.
No fuel reaching carburetor.
6.
Refill the fuel tank.
1.
Move the Switch to the ON
2.
position.
Turn the fuel valve ON.
3.
Top off oil level.
4.
Check that the spark plug wire is
5.
not loose or disconnected. Clean
and re-gap spark plug. Replace if
necessary.
Clean fuel filter cup. Check fuel line
6.
for leaks or obstructions.
Engine misses, is
hard to start or runs
poorly
Fuel filter dirty.
1.
Air cleaner dirty.
2.
Spark plug dirty or wrong gap.
3.
Check and clean the fuel filter.
1.
Check and clean the air filter.
2.
Check, clean and re-gap spark
3.
plug.
Power Light does not
come on
Engine is running poorly.
1.
Ground wire is not connected.
2.
Generator is not functioning.
3.
Improve engine performance.
1.
Connect ground wire.
2.
Take generator to qualified service
3.
technician.
No or not enough
power at the AC
outlets.
AC Breaker switch in the OFF
1.
position.
AC circuits overloaded.
2.
Reset the Breaker Switch to the ON
1.
position.
Disconnect some appliances to
2.
reduce the load.
No power at the 12
VDC outlet.
DC Breaker Switch open.
Disconnect the 12 Volt appliance, then
press the 12 VDC breaker switch IN.
Reconnect the 12 V accessory.
follow all safety precautions whenever diagnosing or servicing the
equipment or engine. Consult a qualified service technician for any
repairs beyond your training or ability.
plEAsE READ ThE folloWinG CAREfullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR ExPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
