8.
Never leave the tool unattended when it is plugged into an electrical outlet.
Turn off the tool and unplug it from its electrical outlet before leaving.
9.
Always unplug the tool from its electrical outlet before performing and
inspection, maintenance, or cleaning procedures.
10.
Be aware of work surfaces. When chipping on walls, ceilings, or floors, make
sure that electrical wires are not below the surface of the work area. Contacting
an electrical wire can cause severe injury and possibly death.
SKU 90814
PAGE 6
11.
WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of Cali-
fornia) to cause cancer, birth defects or other reproductive harm. Some ex-
amples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium from
chemically treated lumber. Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq.)
12.
WARNING! People with pacemakers should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to
a heart pacemaker could cause interference or failure of the pacemaker.
