13.
Oil Tank (69): Refer to the
“Pre-Start Instructions” section in this manual for
full details. (See Figure B.)
14.
Gear Box Grease Fitting (50): The Drive Gear (44) assembly should be filled
(through the Gear Box Grease Fitting) with clean, new, automotive axle grease
every three months or 50 hours of tool use. (See Figure B.)
15.
Spark Plug (55A): The condition of the Spark Plug should be checked every six
months or 100 hours of tool use. If necessary, clean or replace the Spark Plug.
ALWAYS remove the Spark Plug prior to performing any inspection,
maintenance, or cleaning of the Polesaw/Pruner. (See Figure B.)
16.
Choke Lever (48A): The Choke Lever must be set to its “START” position when
starting a
cold Engine (1). Once started, move the Choke Lever to its “RUN”
position. When starting a
warm Engine, make sure the Choke Lever is in its
“RUN” position. (See Figure B.)
17.
Air Filter (42A): The Air Filter should be checked prior to each use of the
Polesaw/Pruner for excessive dirt and debris build-up. Thereafter, the Air Filter
should be cleaned or replaced every three months or 50 hours of tool use.
(See Figure B.)
18.
Fuel Tank (78A): The Fuel Tank will hold up to 0.2 gallon of fuel. Always make
sure the Fuel Cap (74A) is securely replaced after filling the Fuel Tank. NEVER
attempt to fill the Fuel Tank when the Engine (1) is running or hot to the touch.
Refer to the
“Pre-Start Instructions” section in this manual for full details on
filling the Fuel Tank with the proper unleaded fuel/2-cycle oil mixture.
(See Figure B.)
19.
Starter Handle (4A): Refer to the
“To Start The Polesaw/Pruner” section in
this manual for full details. (See Figure B.)
PRE-START INSTRUCTIONS
To Fill The Chain Oil Tank:
1.
Prior to each use of the Polesaw/Pruner, the Chain Oil Tank (69) must be filled
with S.A.E. 30 weight oil (below 34 Fahrenheit) or S.A.E. 40 weight oil
(above 75 Fahrenheit). (See Figure B.)
o
o
SKU 95283 For technical questions, please call 1-800-444-3353 PAGE 11
12.
Guard Bar (73): Always place the Guard Bar Cover (78) on the Guard Bar
when transporting or storing the Polesaw/Pruner. The Guard Bar Cover fits
snugly onto the Guard Bar and must be attached carefully due to the sharp teeth
of the Saw Chain (74). Always wear heavy duty work gloves when installing the
Guard Bar Cover. (See Figure B.)
