Page 9
SKU 97114
For technical questions, please call 1-800-444-3353.
SpeciFicatiOnS
Electrical Requirements 120 V~ / 60 Hz
Temperature Range
430° F to 1160° F
Fan Speed
HI - LOW
AMP Draw
4.6A (low), 10.0A (high)
e179876
unpacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Operating inStructiOnS
read the entire iMpOrtant
SaFetY inFOrMatiOn section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
tool Set up
tO preVent
SeriOuS injurY
FrOM accidental
OperatiOn:
turn the power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
Work piece and Work area Set up
Designate a work area that is clean
1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord along a safe
2.
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to
allow free movement while working.
Secure loose workpieces using a vise
3.
or clamps (not included) to prevent
movement while working.
There must not be hazardous
4.
objects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
general Operating instructions
Plug the Power Cord of the tool into a
1.
120 volt, grounded, electrical outlet.
The power button on this heat gun
2.
has three stages. Push once for the
low setting, push twice for the high
setting, and push three times for the
Automatic Cool Down Stage. The
heat gun will run for 80 seconds in
the cool down stage and then auto-
matically turn off. The green LED
light is illuminated when the gun is
in the cooling function.
note:
If the
heat gun is being operated at “LO”
temperature range, the user should
push the POWER button twice to
start the cool air function, and after
cooling for approximately 80 seconds
the unit will shut down completely.
If the heat gun is being used at 141
temperature range, the user needs
