SKU 99702
For technical questions, please call 1-800-444-3353.
Page 9
speciFicAtiOns
Electrical Requirements
120 V~ / 60 Hz /
7.5 A
Motor
3/4 HP
Operating PSI
2350 – 2650 psi
Paint Flow
0.33 GPM
Fuse
Class F, F10A/250 V
Hose Size
1/4”
Oil Requirement
Hydraulic Oil
unpAcKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
instructiOns FOr
putting intO use
read the entire impOrtAnt
sAFety inFOrmAtiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
tO preVent
seriOus injury
FrOm AccidentAl
OperAtiOn:
turn the power switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Turn the knobs on the handle coun-
1.
terclockwise, pull the handle up, and
secure it by turning the knobs clock-
wise. Repeat with lower knobs to
raise the Sprayer to the correct height
for the job. The Sprayer should be
1/4” above the bottom of the pail.
Knobs
2. Insert the ends of the hose bracket
into the holes on the inside of the
handle.
Remove the hex nuts on the front of
3.
the unit, then use them to secure the
pail bracket to the unit.
prime/sprAy
Knob
pail Bracket
REV 08j
