Page 11
SKU 97047
For technical questions, please call 1-800-444-3353.
Cleaning, maintenance, and lubrication
BeFore eACH uSe,
inspect the general condition of the tool. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts and
any other condition that may affect its safe operation.
AFter uSe,
clean external surfaces of the tool with clean, moist cloth.
Due to the sensitive wiring and electrical circuits within this device, and the
possibility of injury, the fuses inside this unit are to be replaced only by a
qualified technician. Also, this unit must have all energy storing electronics
discharged before opening; test for voltage to verify that the unit is safe before
opening.
troubleshooting
1.
If the low battery alarm sounds, this means that the input voltage is below the
necessary 10. V. The battery needs recharging. You should stop using the
appliance and then recharge the battery. If this is not done, the Inverter will shut
off automatically at around 10 V.
2. If you are unsure if the inverter will have the proper amount of current to run the
device, use this rough guideline: Take the power consumption of the load in watts
and divide it by 12 (input voltage). The result will be the approximate number of
amps needed to power your device.
Example: Load is rated at 312 watts. 312 watts / 12 V = 2 amps needed. You
could use this device with the inverter.
3. If your television will not start, it is important to keep in mind that some appliances
(including many televisions) may require two to six times their wattage to start up.
4. If your audio system buzzes while using this inverter, it is because some sound
systems can not filter out the modified sine wave produced by the inverter. Use a
sound system that incorporates a higher quality power supply.
. This inverter is made to minimize the interference with TV signals. However,
especially with weak TV signals, some interference may still be visible. To correct
this, place the inverter as far away as possible from the television antenna and it’s
cables. Next, adjust the orientation of the inverter to the antenna cables and TV
power cord to minimize the interference. Also, use a shielded antenna cable.
. If the low battery alarm is on all the time, try these corrective measures: Recharge
battery if in poor condition. Next, check the battery connection. You may need to
clean the connectors.
7. If you are getting a low output voltage, try reducing the load to minimize watts. You
may have overloaded the inverter. Reduce your load to 90 watts. Also, keep input
voltage above 10.5 volts to maintain a constant flow of power.
8. If you are not getting any power output, turn the power switch Off and On again,
until the green power light comes on. Your devices may draw too much power to
operate them. The inverter may be in thermal shutdown. Let it cool down and make
sure there is adequate ventilation around the unit.
1.
2.
3.
