5
The three bolts circled here are used to
change the pitch and to level the projector.
Raising or lowering the nut in the rear
will change the pitch of the projector,
which will raise or lower the image on
the screen
Adjusting the bolts on either side of the
front will help level the projector,
making the image square on the screen
Adjust the 2 front nuts to change how level
the projector is. This will ensure that the
text on screen is straight.
When it is aligned, the projector itself
will not necessarily be level. To align it
correctly, the projector might be tilted
left or right.
When the projector is correctly aligned,
tighten the nuts on top, then the wing
nuts below.
This side view shows how to adjust the
pitch of the projector
Raising the 2 front nuts and the rear nut
will raise the projector
Raising the 2 front nuts and lowering
the rear nut will move the projected
image up
Lowering the 2 front nuts and raising
the rear nut will move the projected
image down
Manually focus the projector
with the focus ring above the
lens when it is in position.
Adjust the focus so the
center of the screen is the
most clear.
Summary of Contents for GalacTix
