Chicco Polly Progress, Instructions For Use Manual

8

9

that the product and all its compo-

nents don’t show signs of damage 

caused by transportation.

•  WARNING:

 Do not use the seat if it 

has any broken or damaged parts.

•  WARNING:

 When not in use, the 

seat must be kept out of the reach 

of children.

•  WARNING: 

Do not use the seat with 

more than one child at time.

•  WARNING:

 Before mounting the 

seat on the stool structure, make 

sure that the structure is properly 

fastened and all its components are 

assembled correctly.

•  WARNING:

 Do not step up on the 

stool.

COMPONENTS

A – Seat
B - Stool structure
C - Seat rear fastener
D - Seat front pins
E - Seat release sliding buttons
F - Leg rest
G - Leg rest adjustment buttons
H - Rear fastener slot
I - Front pin fastening holes

CLEANING & MAINTENANCE 

Clean with a soft cloth soaked in water. Never use abrasive 
detergents or solvents. 

USE

The highchair can be used in stool mode for children aged 
36 months and older and weighing up to 30 kg.

INSTALLATION

To install the seat “A” correctly on the stool structure “B”:
1)  Fold the leg rest “F” using the side adjustment buttons “G” 

and making it turn completely to the back of the struc-
ture until it reaches closed position (Fig. 1-2).

WARNING: When using the seat, the leg rest must be kept 
in closed position.
2)  Take the seat “A” from the sides and insert the rear fasten-

er “C” in the slot “H” on the stool “B” (Fig. 3-4).

3)  Then turn the front part of the seat “A” down and push on 

the front part until you hear the engagement click of the 
front pins “D” in the holes “I” in the stool structure (Fig. 5).

REMOVAL

To remove the seat “A” correctly from the stool structure “B”:
1)  Lower the stool structure surface following the instruc-

tions supplied with the highchair to have better access 

to the stool release sliding buttons “E” (Fig. 6).

2)  By operating the sliding buttons “E,” turn the seat up to 

release it completely (Fig. 7-8-9).

WARRANTY

The product is guaranteed against any conformity defect in 

normal conditions of use as provided for by the instructions 

for use. The warranty shall not therefore apply in the case 

of damages caused by improper use, wear or accidental 

events. For the duration of warranty on conformity defects 

please refer to the specific provisions of national laws appli-

cable in the country of purchase, where provided.