Chicco SDRAIETTA, Manual

13

t 

-

-

e 

-

e 

.

n 

-

e 

g 

-

-
-

t, 

k 

6. 

al 

e 

) 

8.  Always fasten the safety harness, inserting it through 

the crotch strap (G), and check that the harness fas-
tens baby correctly and that it is adjusted/tensioned 
correctly (diag. 8). 

HOW TO ADJUST THE BACKREST

9.  To adjust the backrest, turn the side joints (E) (diag. 

9) and recline the backrest to the desired position; 
lock the joints by turning them in the opposite direc-
tion (diag.10).  This operation may be carried out with 
the child sitting in the bouncing chair, although it can 
be more difficult.  Always hold the backrest with one 
hand while adjusting its position.

HOW TO ADJUST THE FOOTREST

The footrest can be adjusted to two positions.
11.  Low position: Press the buttons, located on the front 

joints (F), and, at the same time, push the footrest in 
a downward direction.  A click is heard, signalling that 
it is locked into position (diag.11).

12.  High position: Press the buttons and push the foot-

rest in an upward direction.  A click is heard, signal-
ling that it is locked into position (diag.12).

ROCKING POSITION

The baby chair can be used in the “rocking” position. 
13.  Turn the rear handle (B) following the direction of 

the arrow (diag.13).

14.   When you wish to use the bouncing chair as a baby 

chair, turn the handle in the opposite direction to 
prevent rocking (diag.14).

HOW TO REMOVE THE COVER 

The cover of the baby-bouncing chair can be removed 
and cleaned.
15.  Remove the safety harness from the “D” rings; then 

remove the cover starting from the front, first from 
the footrest, unfastening the Velcro straps located 
underneath, and then from the backrest (diag.15).

16.  To replace the cover onto the bouncing chair, repeat 

the above operations in the reverse order, sliding the 
lower fabric strap through the adjusting joints of the 
backrest (E), as shown in diagram 16.

WARNING: Fit the safety harness again, checking that 
it has been fitted correctly through the holes of the “D” 
rings and the crotch strap.
 

PILLOW / INSERT

The comfort pillow (C) is ideal from birth, and it can be 
removed at later stages of the child’s growth.  The soft 
padding and breathable fabric ensure maximum com-
fort during the first months.
17.  To fit it to the seat, insert the crotch strap (G) into 

the correct opening of the pillow/insert, as shown in 
diagram 17.

CADDY ENJOY BOUNCING CHAIR

The CADDY ENJOY range features fabrics with special 
colours, which are used with a wide range of Chicco 
Nursery products.  For instructions on how to use the 
bouncing chair, please refer to this instructions booklet, 
with the exception of the “Pillow / Insert” section.

For further information or spare 
parts requests, please contact
Chicco UK Ltd Customer Service:
Postal address: CHICCO UK LTD
PROSPECT CLOSE
KIRKBY IN ASHFIELD
NOTTINGHAMSHIRE - NG17 7LF
Telephone: 01623 750870
Website: www.chicco.co.uk 
section “contact us”