CMS495
Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively “Milestone”), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the CMS495 up to (and including)
the projector does not exceed 50 lbs (22.7 kg).
IMPORTANT ! :
The CMS495 was designed specifically
to be used with the UL Listed CMS440 Lightweight
Suspended Ceiling Kit in order to make it compatible with
ceilings angled up to 45°. Do NOT attempt to use the
CMS495 with any other type of ceiling mount or with
ceilings angled more than 45°!
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING:
Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
EQUAL 1
(REAR ANGLE)
EQUAL 1
(FRONT ANGLE)
45° MAX INSTALLED ANGLE
EQUAL 2
(SIDE ANGLE)
EQUAL 2
(SIDE ANGLE)
EQUAL 3
(SIDE ANGLE)
EQUAL 3
(SIDE ANGLE)
AND EQUAL-3)
FRONT CABLE
CROSS CABLES
REAR CABLE
TO THE OPPOSING MOUNTING POINT ON THE CEILING
THE CROSS CABLES SHOULD INSTALL TO THE FRONT OR BACK OF THE PLATE AND MOVE
PLUMB
LINE
PLUMB
LINE
2.
NOTE:
ANGLES FROM PLUMB LINE (BETWEEN 10 AND 30 DEGREES) FOR THE FRONT AND BACK
1.
OUTER CABLES (NOT THE CROSS CABLES) SHOULD BE AS CLOSE TO EQUAL IN EACH
PLANE AS POSSIBLE. THE FRONT AND REAR ANGLES FOR THE FRONT AND REAR CABLES
SHOULD BE CLOSE TO EQUAL (LEFT DRAWING EQUAL-1), AND THE SIDE ANGLE FOR THE
FRONT AND REAR CABLES SHOULD BE CLOSE TO EQUAL (CENTER DRAWING EQUAL-2,
538.4
21.20
PLUMB
LINE
PLUMB
LINE
203.2
8.00
