CMS495
Installation Instructions
6
Installation to Ceiling
1.
Follow CMS440 installation instructions to complete
installation to ceiling, using four cables and cable locks
used with the CMS440 for the front and rear cables (See
Figure 4) and then the four cross cables (D) and four cable
locks (E). (See Figure 5)
NOTE:
The cross cables should install to the front or back of
the plate and move to the opposing mounting point on
the ceiling. (See Figure 5) and (See Figure 6)
Figure 4
Figure 5
IMPORTANT ! :
Angles from plumb line (between 10° and
30°) for the front and back outer cables (not the cross cables)
should be as close to equal in each plane as possible. The front
and rear angles for the front and rear cables should be close to
equal (upper drawing - Equal 1). The side angles for the front
and rear cables should be close to equal (lower drawing - Equal
2 and 3). (See Figure 6)
NOTE:
Specific angles will vary depending on angle of the
ceiling.
Figure 6
CMS440 cables
(D) x 4
EQUAL 1
(REAR ANGLE)
EQUAL 1
(FRONT ANGLE)
45° MAX INSTALLED ANGLE
EQUAL 2
(SIDE ANGLE)
EQUAL 2
(SIDE ANGLE)
EQUAL 3
(SIDE ANGLE)
EQUAL 3
(SIDE ANGLE)
FRONT CABLE
CROSS CABLES
REAR CABLE
PLUMB
LINE
PLUMB
LINE
PLUMB
LINE
PLUMB
LINE
