FSB-4226
Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
MOUNTING SYSTEM:
A MOUNTING SYSTEM is the
primary product designed by Chief® to mount the projector or
display.
ACCESSORY:
An ACCESSORY is any product designed by
Chief® to complement the primary mounting system either by
mounting any supporting components or enhancing the
mounting capabilities of the primary mounting system.
COMPONENT:
A COMPONENT is any secondary product to
be mounted to an accessory, i.e. speakers, CPU’s, cameras,
tablets, additional displays.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all mounting systems/
accessories are properly assembled and installed using the
instructions provided.
WARNING:
Failure to provide adequate structural strength
for this accessory can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this accessory is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
mounting system. The wall to which the mount is being
attached may have a maximum drywall thickness of 5/8"
(1.6cm). Do not install drywall anchors into the seam between
drywall pieces.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the FSB-4226 bracket including
the display does not exceed 45 lbs (20.41 kg).
WARNING:
Use this accessory only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING:
Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and
repair.
WARNING:
Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
0.668
2.105
2.636
4.605
7.105
9.209
0.668
2.105
2.636
6.573
7.105
8.542
9.209
MOUNTING BUTTONS FIT
INTO SLOTS ON Q2 SERIES MOUNT
ATTACH TO KONTOUR TYPE
MOUNT USING THESE HOLES
THREAD ENGAGEMENT W/
20 MM SCREWS
0.286
THREAD ENGAGEMENT W/
25 MM SCREWS
0.505
