K2W Series
Installation Instructions
8
Figure 1
(F) x 2
(E)
(G) x 2
3
4
5
set screw
6
side view
(A)
Assembly And Installation
Connecting K2W Series (wall mount) to Wall
1.
Determine mounting location on wall.
2.
Use a stud finder to locate 2" x 4" wood stud.
3.
Use wall bracket (E) to mark and drill two 1/8” x 2 1/2” holes
in wall at desired mounting location. (See Figure 1)
IMPORTANT ! :
Only top and bottom holes of wall
bracket (E) must be used to attach bracket to wall as
shown in Figure 1. Do NOT use any other holes to secure
bracket to wall!
4.
Use two 1/4-2 1/2” hex head lag screws (F) and two 1/4”
washers (G) to install wall bracket (E) onto wall. (See
Figure 1)
IMPORTANT ! :
Over tightening screws (F) may cause
bracket to compress into soft wall surface resulting in
difficult mount installation or improper engaging of set
screw in Step 6.
5.
Hang monitor arm (A) over wall bracket. (See Figure 1)
6.
Secure monitor arm to wall bracket by tightening set screw.
Ensure set screw engages back side of wall bracket (E) to
properly secure mount. (See Figure 1)
Array Installation (K2W21H and K2W22H
Models ONLY)
1.
Slide rotational spacer (J10) into opening on array
attachment bracket. (See Figure 2)
2.
Use 5/16-18 x 3" button head cap screw (J3), two thin steel
washers (J8), plastic spacer (J9), pocket washer (J5), pivot
pin (J4), pivot point spacer (J12) and 5/16-18 lock nut (J6)
to secure array (J1) to K2 arm (A). (See Figure 2)
NOTE:
Cable clip (J11) can be used in place of pivot point
spacer (J12) if additional cable management is desired.
(See Figure 2)
Figure 2
(J10)
1
(J3)
2
(J9)
(J8) x 2
(J5)
(J1)
(J4)
(J6)
(A)
(J12)
or
(J11)
(K2W22H shown)
