Installation Instructions
KWT-110
13
4.
Drill three 7/64" holes. (See Figure 15)
5.
Install three #12 x 2 1/2" round pan wood screws (R)
through small center bracket holes and into drilled holes.
(See Figure 16)
Figure 16
Vertical Installation on Drywall
WARNING:
Drywall must be at least 1/2" thick in order to
install wall track accessory.
1.
Using wall track accessory (A) as a template, mark location
of six mounting holes on wall making sure it will be level.
(See Figure 17)
Figure 17
2.
Drill six 1/2" holes at locations marked in Step 1. (See
Figure 18)
3.
Hold metal channel on anchor (K) flat alongside plastic
straps and slide channel through hole. (See Figure 18)
Figure 18
4.
Holding plastic straps on anchor (K), pull anchor away from
wall until channel rests flush behind wall making sure
anchor channel is positioned vertically on stud. (See Figure
19)
5.
Slide plastic cap on anchor (K) towards wall until flange of
cap is flush with wall. (See Figure 19)
Figure 19
6.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 20)
7.
Repeat steps 3 through 6 for each mounting hole.
(R) x 3
5
(A)
(A)
1
2
X 6
X 6
(K) x 6
Drywall
Plastic Straps
3
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
(K) x 6
5
