MFAUBSP
Installation Instructions
8
WARNING:
Display may be very heavy! Ensure display
may be safely lifted and maneuvered as required to install on
cart. Failure to take adequate precautions can result in
serious personal injury or damage to equipment!
6.
Hang interface brackets (A and B) to interface head
assembly (E). (See Figure 5)
7.
Use 1/4-20 x 1 1/4” socket head cap screws (MI) to secure
interface brackets (A and B) to rails for each display. Screws
must engage through both holes to be fully secured. (See
Figure 5)
Figure 5
IMPORTANT ! :
In order to ensure an even mount, install
uprights to be centered over column assembly. Do NOT
install both uprights to the same side of column
assembly! (See Figure 6)
Figure 6
Cable Management
NOTE:
The following cable management options may vary
based on type of display being mounted and user
preference.
1.
Place FCA clip (N) into groove on back of Fusion mount with
clip handle in a vertical position. (See Figure 7)
2.
Rotate FCA clip (N) 90° in either direction until clip handle is
in a horizontal position. (See Figure 7)
3.
Repeat Steps 1-2 for all clips to be installed.
Figure 7
4.
Route cables along FCA clips to be used for cable
management. (See Figure 8)
5.
Use cable ties (P) to secure cables to FCA clips. (See
Figure 8)
Figure 8
(MI) x 2
underside view
7
1
2
2
clip handle
(N)
4
5
(P)
