CHIEF MSP-DCCPPNR, Installation Instructions Manual

Part # MSP-DCCPPNR
Large Flat Panel Dual Arm Wall Mount

The MSP-DCCPPNR is wall-mounted, rugged, versa-
tile, and installer-friendly. The mount is compatible 
with the standard (14” x 14”) PSB interface bracket in 
which a display can be mounted in either the land-
scape or portrait position on the mount.

The dual arms on the MSP-DCCPPNR:

•

Extend from the wall 24-7/8” in length

•

Pivot up to 90º left or right of center

The standard mount is shipped with the support posts 
for the dual arms centered in the mount. The support 
posts can be moved laterally right or left of center to 
readily accommodate sites with limited wall space. 
The mount also has two inches of height adjustment. 
The tilt range for the display is 5º up and 15º down.

The MSP-DCCPPNR was designed for fast installa-
tion. After drawing the plumb line and installing the 
two top lag bolts into the dual wall studs, the installer 
hangs the mount on its top bracket and installs two lag 
bolts in the bottom bracket. Next, the installer makes 
the height adjustment, mounts the display, and con-
nects the power/audio/video cables, which are 
diverted into the built-in path in the swing-out arms. 
After making the lateral, rotational, and tilt adjust-
ments, the installation process is complete.

BEFORE YOU BEGIN                                                                         

•

Caution:  To prevent damage to the PNR, which could affect or void the Factory warranty, and to the equip-
ment that will be attached to it, thoroughly study all instructions and illustrations before you begin the 
installation.  Pay particular attention to the “Important Warnings and Cautions” on Page 2.

•

The combined weight of the components installed on the PNR must not exceed 200 lbs. (90.72kg).

•

The PNR wall mount must be installed on dual wall studs or supporting framework. The wall to which the PNR is 
anchored must be capable of supporting 

five times

 the total weight of the mount and all attached equipment.

•

If a defect is discovered after Dell’s initial 21 day Customer Satisfaction period, Chief Mfg. will, at its option, repair 
or replace the product at no charge provided it is returned during the warranty period.  Please note contact informa-
tion for Chief Mfg. listed below:

CHIEF MANUFACTURING INC.

1-800-582-6480

  952-894-6280  FAX 952-894-6918

8401 EAGLE CREEK PARKWAY, STE. 700
SAVAGE, MINNESOTA 55378  USA

PART NO. 8805-000146  (Rev. B)

2005 Chief Manufacturing

www.chiefmfg.com

10/05

I N S T A L L A T I O N   I N S T R U C T I O N S