CHIEF MSP-DCCPPNR, Installation Instructions Manual

Installation Instructions

MSP-DCCPPNR

13

SWING ARM TENSION ADJUSTMENT

Swing arm tension is pre-set at the factory and is adjusted to 
accommodate displays with weights near the top of the mounts 
capacity.

If smaller displays are used it may be difficult to reposition the 
display after mounting. Swing arm tension can be adjusted to 
compensate for smaller display by:

NOTE: 

The display must be mounted prior to adjusting swing 

arm tension.

1.

Locate the ajustment bar and wrench provided with the 
mount.

2.

Place adjustment bar into socket head cap screw located at 
swing arm pivot point. (see figure 15)

NOTE: 

The display may need to be repositioned in order to 

gain access to the tension adjustment screw(s).

3.

Using the wrench provided with the mount, turn adjust-
ment bar clockwise to increase swing arm tension or coun-
terclockwise to reduce swing arm tension. (see figure 16)  
and  (see figure 17)

NOTE:

 Small adjustments of 1/8 turn or less are typically all 

that is required to achieve desired tension.

4.

Check swing arm tension. If desired tension is present, 
tension adjustment is complete. If additional tension 
adjustment is required, repeat steps 2 and 3 until desired 
tension is achieved.

NOTE:

 If changing from a smaller display to a larger display 

may be necessary to increase swing arm tension.

Adjustment
Bar

Wrench

Socket Head
Capscrew

Figure 15. Pivot Arm Tension Adjustment

Reduce

Figure 16. Reduce Swing Arm Tension

Increase

Figure 17. Increase Swing Arm Tension