Installation Instructions
MSP-DCCPPNR
6
Mount the mount
1.
Mount the top bracket on the mount, as follows:
WARNING: Improper installation can result in serious
personal injury!
a.
With an assistant, lift and hang the mount on the
two lag bolts and washers previously installed on
the wall. See Figure 2.
NOTE: Make sure washers are installed in front of the
top bracket, not behind the bracket.
b.
Slide the mount into the desired position on the
wall and tighten the two lag bolts.
2.
Mount the bottom bracket on the mount, as follows:
a.
Mark the two mounting holes in the bottom
mounting bracket (see Figure 3). Make sure to
align the holes parallel to the holes drilled in the
top bracket.
b.
Drill two pilot holes in the wall studs.
c.
Install two lag bolts and two washers into the
pilot holes.
d.
Tighten the two lag bolts.
Mount (Hang) the mount on Lag Bolts
Figure 2. Mount mount on Lag Bolts
Use Lag Bolts and Washers to Fasten mount to the Wall
.
Figure 3. Mount Bottom Bracket on mount
Summary of Contents for MSP-DCCPPNR
Page 3: ...3 Installation Instructions MSP DCCPPNR DIMENSIONAL DRAWING ...
Page 14: ......