CHIEF MSP-DCCPPNR, Installation Instructions Manual

8

Installation Instructions

MSP-DCCPPNR

MOUNT THE DISPLAY

1.

Make sure power is not supplied (turned off) to the display 
and the locking device is in the unlocked (down) position 
(see Figure 6) before attempting to mount the display.

2.

Following the instructions for mounting the PSB interface 
bracket of your specific plasma display panel, install the 
mounting bracket on your plasma display panel.

WARNING: Watch for pinch points. Do not put your fin-

gers between movable parts.

3.

With an assistant, slide the display down over the mount. 
Make sure buttons of PSB interface bracket fully engage 
all teardrop slots of the mount.

4.

Secure the mounting bracket to the mount by completely 
engaging the locking device (see Figure 6).

WARNING: Make sure the locking device securing the dis-

play is completely engaged at all times except 
when removing or installing the display. The 
locking device must be completely engaged 
during installation/removal of cables when the 
display is mounted.

NOTE:

A padlock may be used on the locking device for 
increased security.

5.

Connect and secure power/audio/video cables,  making 
sure to leave sufficient slack to allow for movement of the 
swing arms.

Figure 6. Locking Device

Lock

Unlock

PSB

Teardrop

Slot

(Typical)

Bracket
Interface