Installation Instructions
MSP-GBARKTP320
5
ASSEMBLY AND INSTALLATION
Mount Assembly
1.
Assemble pole (M) to base (G) using one 3/8-16 x 1" flat
head cap screw (J). (See Figure 1)
Figure 1
2.
Assemble pole clamp (H) to array assembly (A) front using
two 1/4-20 x 3/4" button head cap screws (L) and two
washers (K) using 5/32" hex key (R). (See Figure 2)
3.
Secure pole clamp (H) to array assembly (A) and 14" pole
(M) by tightening two 1/4-20 x 3/4" button head cap screws
(L) using 5/32" hex key (R). (See Figure 2)
Figure 2
4.
Add pipe cap (P) to top of pole (M).
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION:
If display uses a screw size other than those
included in the kit, DO NOT use the screws provided. Using
the wrong screws could result in damage to your monitor.
1.
Install two M4 x 12mm Phillips pan head screws (B) into two
upper mounting holes in display back. (See Figure 3)
NOTE:
DO NOT fully tighten at this time.
Figure 3
2.
Hang display on Centris head. (See Figure 4)
3.
Install bottom two M4 x 12mm Phillips pan head screws (B)
through Centris head mounting holes and into lower
mounting holes in display back.
4.
Tighten ALL four M4 x 12mm Phillips pan head screws (B).
(See Figure 5)
Figure 4
(M)
(G)
(J)
1
(H)
(M)
(K) x 2
(L) x 2
(A)
3
Display
(B) x 2
1
Display
Centris Head
(A)
