MSP-GBARKTP320
Installation Instructions
6
Figure 5
Attach Centris Head to Recessed Mount Display
NOTE:
Refer to table below to select the applicable screw and
spacer combination.
1.
Uninstall end lock using the 5/32" hex key (R). (See Figure
6)
2.
Remove Centris head from array (A). (See Figure 7)
Figure 6
Figure 7
3.
Place display face down on a clean dry surface.
4.
Place four 3/8" or 3/4" nylon spacers (F or E) over four
mounting holes in display back (See Figure 8).
5.
Align Centris head mounting holes with four nylon spacers
(See Figure 8).
6.
Secure Centris head to display using four M4 x 20mm
Phillips pan head screws (C), or four M4 x 30mm Phillips
pan head screws (D). (See Figure 8)
Figure 8
7.
Slide display with Centris bracket onto array rail. (See
Figure 9).
NOTE:
Repeat previous steps for each additional display.
Figure 9
8.
Reinstall end locks into mounting rail using the 5/32" hex
key (R). (See Figure 10)
IF recess DEPTH is: THEN use spacer:
AND screw:
3/8" or less
F (3/8" long)
C (M4 x 20mm)
More than 3/8" up to
and including 3/4"
E (3/4" long)
D (M4 x 30mm)
Display
Centris Head
(A)
(B) x 2
3
Square Nut
End Lock
Centris Head
(A)
3
Centris Head
(A)
Display
Centris Head
(C or D)
(F or E)
6
Display with Centris Bracket
(A)
