Installation Instructions
MSPDCCS4
5
INSTALL ARM ASSEMBLY/WALL PLATE
TO WALL
Wood Installation
WARNING:
Failure to provide adequate structural
strength for this component can result in serious personal
injury or damage to equipment! It is the installer’s
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the structure
as required before installing the component.
1.
Level arm assembly (B) and mark locations of pilot
holes.
2.
Drill four 1/4" (6.4mm) diameter pilot holes into wood
supports.
3.
Install four lag screws (R) through flat washers (Q), arm
assembly (B), and into wood supports.
1
Q x4
B
3
1
x4
2
x4
S x4
9/16" (14.3mm)
1/4"
1a
Concrete Installation
WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT
CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer’s
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the
structure as required before installing the component.
1.
Level base plate (B) and mark locations of pilot holes.
2.
Drill four 3/8" (9.5mm) diameter pilot holes into mounting
surface.
3.
Install four anchors (S) into pilot holes.
4.
Using 9/16" socket wrench, install four screws (R)
through four flat washers (Q) and wall plate (B) into four
anchors (S).
CAUTION:
Do NOT overtighten screws!
4
1
x4
2
x4
9/16"
3
B x 1
3/8"
x4
R x4
S x4
Q x4
