MTTU
Installation Instructions
8
7.
Slowly guide hooks on top of interface brackets on top of
wall plate in desired mounting location. (See Figure 5)
8.
Slowly swing display toward wall. (See Figure 5)
Figure 5
9.
Rotate flags on each interface bracket down to the closed
position in order to lock brackets to wall plate. (See Figure
6)
Figure 6
NOTE:
Flags should stay in locked position unless removing
display from wall bracket.
NOTE:
Display should be held in full vertical position by spring
clips on uprights. For some larger displays, a second
spring clip (DD) may be required in order to hold the
display in the full vertical position. See "Extra Spring
Clip Installation" Section for details.
Tilt Adjustment
1.
Display may be tilted forward by pulling forward on the top
of the display as desired. (See Figure 7)
Figure 7
2.
Tilt tension is adjustable by using 3/16" hex key (AA) in the
tension adjustment nut. (See Figure 7)
NOTE:
Tension should be adjusted equally on each bracket to
ensure even tension distribution.
NOTE:
Due to the low profile of the Thinstall Series, certain
displays may have limited tilt capabilities.
3.
To return display to full vertical position, push display back
against wall until spring clips secure display in vertical
position.
7
8
WALL
9
x 2
(A)
locking flag
tension adjustment nut
1
Side View
(located inside hole)
