Installation Instructions
PAC-Y3
5
Figure 4
3.
Slide threaded studs located on two speaker adapters (G)
through four mounting holes in speaker mount adapter (A).
(See Figure 5) or (See Figure 6)
4.
Secure two speaker adapters (G) to speaker mount adapter
(A) using four Nylock nuts (Q).
NOTE:
(See Figure 5) or (See Figure 6) dependent on whether
you are attaching a YSP-800 or YSP-4000/4100/5100
speaker.
Figure 5
Figure 6
5.
Partially install two 1/4-20 x 1/2" button head cap screws (L)
into top back of speaker mount adapter (A). (See Figure 7)
6.
Slide installed screws (L) on back of speaker mount adapter
(A) through teardrop mounting holes in center speaker
bracket (F). Lower bracket until screws are seated in lower
area of teardrop mounting holes. (See Figure 7)
7.
Tighten two upper button head cap screws (L).
8.
Install two 1/4-20 x 1/2" button head cap screws (L) through
center speaker bracket (F) and into lower mounting holes in
speaker mount adadpter (A). (See Figure 7)
Figure 7
(P) x 4
(G) x 2
(YSP-4000 speaker shown)
(Assembled to speaker)
(G - 2 places)
(A)
(Q) x 4
(YSP-800 shown)
(Assembled to speaker)
(G - 2 places)
(Q) x 4
(A)
(YSP-4000 shown)
(F)
Teardrop
Mounting
Hole
(YSP-800 Shown)
(A)
6
5
(L) x 2
8
(L) x 2
