Installation Instructions
PAC-Y3
7
1.
Install PACY3 onto mount following the instructions
provided with the mount. (See Figure 10)
Figure 10
2.
While supporting speaker assembly, loosen four button
head cap screws (L) securing right and left bottom speaker
brackets (D and E) to center speaker bracket (F) and move
speaker assembly to lowest position. (See Figure 11)
Figure 11
3.
Open latching flag.
4.
Install mounting buttons on display following instructions
provided with mount.
5.
Slide mounting buttons on display into teardrop holes in
right and left speaker mounting supports (B and C), and
lower display until recessed area of mounting buttons is
seated in lower area of teadrop mounting holes.
(See Figure 12)
6.
Close latching flag to secure display to speaker adapter
accessory.
Figure 12
7.
Route wires and cables.
8.
Raise speaker assembly to desired position and secure by
tightening four button head cap screws (L) securing right
and left bottom speaker brackets (D and E) to center
speaker bracket (F).
Mount Assembly
(L) x 4
(F)
Speaker Assembly
2
5
Latching Flag
Display with
Mounting Buttons
3
6
