Model PNR™
Installation Instructions
12
Reconfiguring the Swing Arms to the Left or
Right of Center
To change of the dual swing arm mount configuration:
1. Remove the display from the mount.
2. Remove four bolts (two on the top and two on the
bottom) securing the swing arm assembly to the top
and bottom mounting brackets (See figure 12).
WARNING:
The next step will release the arm
assembly from the mount. The arms and plate may fall
if you are not careful.
3. Move the swing arm assembly to desired location.
•
For Left of Center, see Figure 13.
•
For Right of Center, see Figure 14.
4. Install retaining pin assemblies (one top and one
bottom) and secure using two bolts (one top and one
bottom).
5. Install four bolts (two on the top and two on the
bottom) to secure the swing arm assembly to the top
and bottom mounting brackets (See figure 12).
6. Tighten the bolts.
7. Install the display on the mount.
Figure 12: Adjust- Left of Center
Figure 13: Adjust Swing Arm- Right of Center
Top Bolts
Top Bolts
