Installation Instructions
PTS SERIES
7
NOTE:
Roll tension is preset. If the display does not remain in
the desired position, perform the following roll tension
adjustment procedure.
1.
Remove display following the
Removing Display
section.
2.
Remove four 5/16-18 x 5/8" button head cap screws from
back of post assembly (inserted in Step 2 of
Attaching
Faceplate Assembly
section).
3.
Locate roll tension adjustment nut on back of faceplate.
(See Figure 8)
Figure 8
4.
Partially loosen or tighten the roll tension adjustment nut as
needed.
5.
Re-install the faceplate assembly onto the post assembly
following instructions in
Attaching Faceplate Assembly
section.
6.
Re-mount the display following instructions in
Attaching
Display to Mount
section.
Roll Tension
Adjustment Nut
