Installation Instructions
QMP1MB
5
ASSEMBLY
CAUTION:
Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a handheld screwdriver BEFORE using the hex head drill bit
(G) and power drill to complete the attachment.
1.
Assemble two legs (A) and (B) to the stand cross bracket (F)
using two 5/16-18 x 4-1/4" button head cap screws (L)
through one end cap (D) per leg. (See Figure 1)
Figure 1
CAUTION:
INNER COLUMN IS SHIPPED DISENGAGED
and may pinch hands! Hold both inner column and outer
upright while removing from box.
IMPORTANT ! :
Press cable tie tab to loosen and
remove cable tie from around knob post. (See Figure 2)
NOTE:
Disengage knob on upright BEFORE attaching base to
the upright.
2.
Lift up slightly on the inner column of upright and hold firmly
toward top of upright. (See Figure 2)
3.
Pull out knob on the upright and turn 90° in either direction
to disengage the locking mechanism. (See Figure 2)
4.
Raise the inner column and turn the knob 90° in either
direction to engage the knob and lock the column in place.
(See Figure 2)
Figure 2
NOTE:
Insert and turn screws in order shown (
1, 2, 3, 4
). (See
Figure 3)
Figure 3
5.
Attach upright (E) to leg assembly using four 5/16-18 x 2-3/
4" button head cap screws (K) and four 5/16" washers (M).
(See Figure 3) and (See Figure 4)
Figure 4
(Front view of stand)
(L) x 4
(D) x 2
(A)
(F)
(B)
inner column
Cable
Tie
(Bottom view of stand)
1
2
3
4
(Front view of stand)
(K) x 4
(M) x 4
(E)
