RSME
Installation Instructions
10
PROJECTOR INSTALLATION
IMPORTANT ! :
Model RSME uses optional Chief
"SSM" Series interface brackets. (See Parts
drawing.)
Install Interface Bracket
1.
Partially thread thumb nuts onto Phillips screws until
screw end is visible in top of thumb screw.
IMPORTANT ! :
DO NOT fully tighten thumb
screws at this time.
Threaded Rod Installation
NOTE:
CPA adapter must be removed prior to
installing RSME to threaded rods. See Section
1a for details.
The RSME must be suspended from four #10-24
diameter (minimum) threaded rods (not included) which
are secured to unistrut, angle or channel assembly
overhead structural members (trusses or I-beams)
#10-24 channel nuts (not included).
WARNING:
IMPROPER INSTALLATION CAN
RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Structural members
MUST
be capable of supporting five times the
combined weight of all equipment being mounted.
1.
Carefully determine required mount position.
IMPORTANT ! :
This will require knowing the lens
to screen distance. See projector specifications
for determining this distance.
NOTE:
Threaded rod and installation hardware not
included.
2.
Secure one end of the threaded rod to the structural
member.
3.
Install one #10-24 jam nut (not included) and one
#10 washer on each threaded rod.
4.
Install the RSME on the threaded rod.
NOTE:
Hole in the RSME allows socket wrench access
without unit disassembly.
5.
Secure the RSME to the threaded rod using four
#10-24 nuts (not included) and four #10 washers
(not included).
2
1e
Example Only
(Interface bracket
varies dependent
on projector model)
(A)
1
2
4
x 4
5
