Air Conditioning Centre / Martin Industries Ltd
©
2004 - 2009
1
Model KFR-32GW/X1c rev. 409
Please fully read these instructions before calling for any support or advice.
This equipment must be installed by a qualified Air Conditioning Installer, please give this
guide to your installer. This equipment should be installed correctly by professionally qualified
technicians according to the manufacturer’s specifications and requirements. Please read the
entire instructions before commencing, so you can understand the full process before you
begin. Failure to install correctly as set out in these instructions may render your 12 month
parts warranty null & void.
If the system is installed incorrectly, and as a result is
not operating correctly or is damaged, it is the
responsibility of the purchaser / installer. The supplier /
manufacturer accept no responsibility for sub-standard
or incorrect installations.
Guide to the customer
z
The customer should make provision for a suitable power supply source; the voltage
should be in the range of 90-110% of the rated voltage of the system.
z
The power supply circuit should have MCB leakage protection. The power supply
capacity should be no less than 13 Amps.
z
You are advised to use an independent circuit and a suitably earthed socket / outlet,
although a single system can normally run from a standard domestic ring main.
z
The wiring must be installed by a qualified electrician according to the latest electrical
safety requirements.
z
The air-conditioner must be well earthed; the switch of the main power of the
air-conditioner must be reliably earthed, it is recommended that there is a mains isolator
on the outdoor unit.
z
The power supply should be connected by a qualified electrician.
