Chapter 1
Product
Usage Precautions
36
E
nglis
h
1.4
Precautions for Operation
WARNING
•
Do not suck the following substances:
Flammable substances ... Gasoline, thinner, benzine, kerosene, paints, etc.
Explosive dusts ........... Aluminum, magnesium, titanium, zinc, epoxy, etc.
Sparky dust ................. Dust containing sparks from high-speed cutting
machine, grinder, welding machine, etc.
Fire source .................. Cigarette, and liquid such as oil and chemical
Others .......................... Liquid such as water, oil, chemical
•
Do not use the device in or around an area with flammable, explosive, or
corrosive mist, smoke, or gases.
•
Ensure secure connections, without bending or pulling cables with excessive
force.
Fire or electric shock may result.
•
Ensure that the power supply conforms to the specifications of the device.
•
Use the device to suck dry dust without potential dust explosion.
•
Be sure to connect the ground wire.
CAUTION
•
Do not move the device while in operation.
•
Use the device in locations of pollution degree 2.
•
Use a power supply of overvoltage category II.
•
Turn off the main power switch in case of power outage.
Injury or device damage can occur when power returns.
•
Ensure that filters are installed correctly.
If filters are missing, clogged, or broken, foreign matter may enter the motor,
causing failure.
1.5
Other Precautions
WARNING
•
Do not disassemble or alter the device.
Failure to observe can cause electric shock or injury.
For internal checkup or repair, contact your dealer.
•
Follow the information in the instruction manual when performing installation,
connection, starting, operation, checkup, and fault diagnosis.
Working in a wrong manner may lead to fire, electric shock, or injury.
CAUTION
•
When discarding the device, dispose of it appropriately as an industrial
waste.
Summary of Contents for CKU-080AT3-HC
