Chapter 4 Configuring Settings (MODE SELECT Mode)
CMN004-005
49
E
nglis
h
4.5 Other Setting Mode
The parameters listed below can be set.
• Date/time setting
“4.5.1 Clock Calibration Mode” (page 49)
• Accumulated run time resetting
“4.5.2 Accumulated Run Time Reset Mode” (page 49)
• Setpoint resetting
“4.5.3 Setpoint Reset Mode” (page 50)
4.5.1 Clock Calibration Mode
This mode sets date and time.
1.
Move to the MODE SELECT mode.
2.
Press the Up/Down arrow buttons to move to the other setting mode (“Other Setting”).
3.
Press the ENTER button.
The screen displays “Time Adjust”.
4.
Press the ENTER button.
The date setting screen appears.
5.
Press the Up/Down arrow buttons to change the value.
6.
Press the ENTER button to determine the value.
Set the value in this order: year, month, and day.
7.
After the date is set, the time setting screen appears.
8.
Press the Up/Down arrow buttons to change the value.
9.
Press the ENTER button to determine the value.
Set the value in this order: hours, minutes, and seconds.
10.
To exit this mode, press the MODE SELECT button to return to normal mode.
4.5.2 Accumulated Run Time Reset Mode
This mode resets the accumulated run time
(“Runtime”).
1.
Move to the MODE SELECT mode.
2.
Press the Up/Down arrow buttons to move to the other setting mode (“Other Setting”).
3.
Press the ENTER button.
The screen displays “Time Adjust”.
4.
Press the
Up/Down arrow buttons to change the display to “[Runtime Reset]”.
5.
Press the ENTER button.
The display shows “Reset Runtime Y”, prompting confirmation to reset the accumulated run time.
To reset, press the ENTER button.
6.
To exit this mode, press the MODE SELECT button to return to normal mode.
Summary of Contents for CBA-080AT3-HI
Page 69: ...MEMO ...
