ASSEMBLY / OPERATING INSTRUCTIONS
To store High Chair...
To remove Seat Cushion...
1
1
2
Lower the seat (See page 7). It is recommended to
lower the seat to the lowest height position for storage
purposes.
Fit the tray to the rear legs (See page 8).
Press buttons (a) on each hinge then push the rear
legs towards the front legs (b) until they lock in the
folded position.
Remove metal rings from harness ends.
Feed the harness straps through the slots in seat and
seat cushion on the back and under the seat (a) and
remove the harness.
Release the flaps on either side of the arm rests by
pulling the press studs from the inner armrests (b).
Lift the cover off the seat (c).
Refitting the seat cushion is a reversal of this procedure.
When refitting the harness ensure the butterflies on the
ends of the harness straps are opened out correctly
(d) and refit metal rings.
1a.
1b.
1c.
1a.
1b.
1c.
2a.
2b.
a
b
a
d
a
c
b
d
a
c
b
9
