48
10. Troubleshooting Guide
Problem
Solution
Outdoor sensor
array does not
communicate to
the display
console.
The sensor array may have initiated properly and the
data is registered by the console as invalid, and the
console must be reset. Press the reset button as
described in Section 5.2.
With an open ended paperclip, press the reset button
for 3 seconds to completely discharge the voltage.
Take out the batteries and wait one minute, while
covering the solar panel to drain the voltage.
Put batteries back in and resync the console with the
sensor array about 10 feet away.
The LED next to the battery compartment will flash
every 16 seconds. If the LED is not flashing every
16 seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the
polarity. If the sensor is flashing every 16 seconds,
proceed to the next step.
There may be a temporary loss of communication
due to reception loss related to interference or other
location factors,
or the batteries may have been changed in the
sensor array and the console has not been reset.
The solution may be as simple as
powering down
and up the console
(remove AC power and batteries,
wait 10 seconds, and reinsert AC power and
batteries).
Temperature
sensor reads too
high in the day
Make certain that the sensor array is not too close to
heat generating sources or strictures, such as
buildings, pavement, walls or air conditioning units.
Summary of Contents for 22515
Page 37: ...37 List display Weather Map ...
