operation manual
Status: 11/2021 - Version 1.08
page 6
Item no. 21198
Programming of the main and the secondary alarms
Tip: It doesn't matter which detector is the main detector or secondary detector, if all detectors have been correctly
trained, the alarm will sound on all detectors, regardless of which detector detects the smoke development first! The
permanent wireless connection of all smoke detectors can be released and, if necessary, renewed by removing the 3
mignon batteries (for approx. 5 minutes) (see 1-4). Turn the smoke alarm counter-clockwise. Remove the mounting
plate. Hold the mounting plate at the position where you will mount the smoke alarm. Test all detectors to be
installed by pressing (3-5 sec) the test button. The alarm will turn off after a few seconds. The radio connection system
is based on the main and secondary detector principle. It is best to place all detectors to be installed/connected next
to each other.
1. Insert fresh/new batteries, pay attention to the correct polarity!
2. Take the first detector (it will become main) and press the LEARN button twice in a row, then the green LED
should light up! (remains approx. 18 seconds, as long as the detectors can be connected together.)
3. Take one or more additional detectors (these become secondary) and press the LEARN button on this (..or all)
once, the red LED should light up.
4. Now press the TEST button on the main detector within 18 seconds. The main detector acknowledges with an alarm and
the secondary detectors should now also trigger an alarm. The alarm goes off again after a short time. Now check again by
pressing a test button whether all smoke detectors (..with a 1-2 second time delay) trigger an alarm.
Installation on wall or ceiling:
Turn the smoke alarm counter-clockwise. Remove the mounting plate.
• Hold the mounting plate at the position where you want to mount the smoke detector. Mark the holes with a pencil.
These positions are necessary for the mounting holes.
• Drill 2 holes according to the markings. The diameter of the holes must be 5mm. Insert a plastic anchor into each of
the 2 holes.
• Place the mounting plate on the plastic dowels. Fasten the mounting plate to the dowels with the screws (see figure
5). • Insert the battery into the battery compartment.
• Place the smoke detector on the mounting plate. Rotate the smoke alarm clockwise until the smoke alarm clicks into
place. (Note: Mounting plate can only be mounted with battery installed).
• Test the smoke detector with the test button. To avoid accidents, properly mount the smoke detector on the wall or
ceiling according to the mounting requirements.
Tip:
The smoke detector cannot be placed on the mounting
plate without batteries:
This safety precaution protects you from forgetting the
batteries!
Reproduction only with the permission of
ChiliTec GmbH, Bäckerberg 12, 38165 Lehre
EAR (WEEE): DE25841852
LUCID PackagingG: DE5562476395648
GRS (UBA Register) No.: 21003466
