Status: 12/2021 - Version 1.02
Page 2
Wall lights "Portao" with BWM
Details variants: (EEKL = energy efficiency class according to 2019/2020 / EU & 2019/2015 / EU)
Item No.
Color / type
power
Consumption / 1000h
Lumens
Kelvin
EEKF
dimmable
Outside dimension / Ø
Protection class
23080
White
15 watts
15kWh
1000lm
4000K
G
no
232x88x53mm
IP44
23153
anthracite
15 watts
15kWh
1000lm
4000K
G
no
232x88x53mm
IP44
Installation instructions and explanations for the table
All "Portao" lights may only be installed by qualified electricians - electricity is dangerous.
safety instructions
• Never open the product, there are no serviceable parts - only by qualified personnel.
• The product must never come into contact with water, not even in other liquids.
• The product must not be exposed to heat (> 40 °) or high humidity (> 80%).
• Make sure that the cable is not kinked, squeezed, pinched or run over.
• Before connecting, check that the operating voltage (product) matches the mains voltage.
• Operation is only permitted on 230V ~ / 50Hz mains voltage
• Never touch the product, power cord or plug with damp hands.
• Remodeling, changing or expanding the product is not permitted.
Installation instructions for power connection:
Fasten the two wires of the supply line in the internal luster terminal. The luster terminal is labeled L (phase) and N
(neutral conductor). Connect the wires via the terminal and check that they are securely held in the terminal. Any
incoming protective conductor (PE) that may be present must be electrically isolated within the luminaire. The
protective conductor is not required due to the complete plastic housing. Screw the transparent protective cover with
the enclosed screws and close the lamp, making sure that it is tight. The feedthroughs must be opened exactly to
match the cable diameter so that the seal is very tight and watertight after the feedthrough.
Function test in daylight
1. Set the Time / Zeit controller
to the lowest level, 10s. 2. Set
the Lux controller to the highest
level, sun symbol. If a person
enters the detection area, the
motion detector should trigger
and switch off again after the
set 10s. Note that the device
reacts to changes in heat. See
the next page.
Separate safety instructions for LED lighting
Never look directly or unprotected into the light or the glowing LEDs. The brightness can dazzle you, you risk injuries
and possible permanent damage to the eyes or the retina. Never point the light at people or animals (... if the light is
mobile)! The product must never be covered during operation and the possibility of heat dissipation into the
environment must be guaranteed. Fire hazard!
Reproduction only with permission from
ChiliTec GmbH, Bäckerberg 12, 38165 Lehr
EAR (WEEE): DE25841852
LUCID Packaging Act: DE5562476395648
GRS (UBA register) no .: 21003466
