•
you connect the pump hose tightly to the piping, so that the pressure
variations caused by the condensation water pump do not remove the hose
from the pipe.
Note! Do not push the hose too far into the sewerage pipe. The hose’s end should
be about 30–50 mm inside the seal.
•
you cut the hose to a suitable length.
Note! Do not extend the condensation water hose with another hose.
Connection to sewerage:
1. Pull the condensate hose through the drainage adaptor to desired length.
2. Cut off any excess hose, leaving 30 to 50 mm inside the adaptor.
26 (40)
Copyright © 2020. All rights reserved.
GIANT Vari – Installation, Operation, and Maintenance Manual
N02541445 Rev. A