Chiltern Invadex LiteTrack Portable Gantry
4
Check all components are available prior to assembly.
Notes:
If the gantry is to be assembled over a bed
The gantry can be assembled over a bed
unless
it is occupied. If the
bed is occupied assemble the gantry away from the bed and then
position afterwards (as a guide this would be approximately 900mm
from the head board but
always ensure the gantry track is directly
above the clients centre of gravity
).
1. Preparation
1. Unpack all components and lay on the floor ready for assembly.
2. Check all parts are available (see Fig 1) and for damaged components.
3. Safety note: The corner quadrant located on the end beam (see Fig 1)
should always have tension. Check to ensure it does not swing freely
and there is tension.
2. Leg assembly
Loosen both black handwheels on the leg as Fig 2 (C & D). Push both
release levers in with one hand as Fig 2 (A), pull out the inner leg
section to the first position as Fig 2 (B) having let go of the release
levers. This should then ‘click’ into place (the pin will be flush with the
top of the block when in the correct position). Secure the leg with the
locking knob Fig 2 (C). Note: The height of the unit can be adjusted later
when the gantry is fully assembled.
A
A
A
B
C
D
LiteTrack Gantry Assembly
Instructions
Fig 2
Foot section x 2
Leg section x 2
Cassette x 1
End beam x 2
Foot section x 2
Leg section x 2
Cassette x 1
Gas strut x 2
Corner
quadrant x 2
Fig 1
User Guide
17
Lifting capacity
210 Kg (33 stone)(460 lb)
including hoist
Construction
Legs - steel
Track - Aluminium
Cassette - Aluminium with ABS cover
Lifting Range
Approximately 1525mm - 1825mm
Maximum loading per foot
100kg (16 stones) (220lb) (provided that the gantry is used in
accordance with the instructions in this user guide)
Assembled component weights:
Lower Leg section (x2) 7kg each (15.5lb)
Upper Leg section 8kg each (18lb)
Cassette (x1) 11kg (24lb)
End section/corner quadrant (x2) 5kg each (11lb)
Gas strut (x2) 1kg each (2.2lb)
Total weight of gantry 53kg (116lb)
CE MARK
The Chiltern Invadex Wispa LiteTrack Gantry carries the CE mark and complies with EC Directives:
Medical Device Directive(93/42/EEC)
Further assistance
Please telephone any Chiltern Invadex Office for further assistance.
Remember that service calls made after the guarantee period will be
chargeable. If the maintenance of the equipment is the responsibility of a
third party, for example the Social Services, please contact them in the first
instance.
Gantry Specification
2165 - 2465
(50mm intervals)
1010 - 1530
440
Gantry at highest position 1825
Gantry at lowest position 1525
2040 - 2560
1890 - 2410 (Internal)
1100
