SNA8110T Gepon OLT User Manual
陈泽科技有限公司
www.stephen-tele.com
The priority range determines how many links may be registered in each priority level. This command should be applied immediately
before registering any links, or after links are deregistered using the Disable OLT command. It is a good idea to configure the OLT in
strict boot mode, allowing the host software time to apply this command and then explicitly enable the OLT to register links.
The OLT must be disabled prior to applying this command; otherwise the OLT FIFOs will become corrupt. It is recommend that this
operation be performed once during the initial bring up of the PON.
7.4 Shaper Drop Down Weights
This command is not available for the TK3721, and applies to future chipsets only. The TK3721 has a strict priority FIFO scheduler.
7.5 DBA Drop Down Weights
DBA drop down weights are used by the DBA to reserve bandwidth for each priority level. This allows the OLT to fix the latency and
reserve a percentage of bandwidth for links in each priority level.
The drop down weight for priority level n
MUST
be greater than or equal to the provisioned DBA Weight for all links in priority level n +