SNA8110T Gepon OLT User Manual
陈泽科技有限公司
www.stephen-tele.com
8.1 OLT Port Management
Allows the user a simple interface to control port parameters such as line speed and flow control. If Auto Negotiation is enabled, the
speed and duplex settings used will be based on the result of negotiating with the link partner. Default values depend on the
personality settings. The table below describes the Set command. In the current firmware release, flow control is not auto negotiated. If
flow control is enabled the firmware will configure the Phy to advertise flow control. Note however that pause frames will be
transmitted regardless of the capabilities reported by the link partner.
8.1.1 Configuring Port in Loop
Allows the user to set a loop back, currently the loop back position must be set to MAC.
8.1.2 Manage Flow Ctrl Parameters
流控参数管理
流控参数管理
流控参数管理
流控参数管理
Sets the flow control on/off threshold values.
For the Flow Ctrl thresholds: the precision of the values is less than the displayed percentages. So small changes between the
provisioned and actual value may exist
9 OLT Traffic Management
The traffic management panel allows the user to change bridging modes, apply complex filters, and expose many of the OLTs advanced
hardware and software features related to traffic management.
9.1 Bridging Configuration Bridging