SNA8110T Gepon OLT User Manual
陈泽科技有限公司
www.stephen-tele.com
The learned IPv4 address table is exposed by the L3 Table tab on the GUI
If any of the checkboxes in the Mode box are checked the L3 switching shall be enabled.Otherwise L3 switching is disabled.
If desired, Relay Agent IP SA may be provisioned with the same value as the IGMP Proxy.
All L3 parameters must be selected in-order for the OLT to insert DHCP Option 82 into upstream DHCP frames.
Currently the OLT appends DHCP Option 82 to all L3 frames.
The Relay Agent IP must be an IP on the same subnet as the DHCP server.
If the L3 switching function is enable the Dyn. IP Learn. Table Size field should be provisioned with a non-zero value.
10 Alarms
The OLT alarms manger works in concert with the ONUs to provide enhanced management capabilities
and complementary set of OLT specific alarms. Features include:
A common management interface for ONU and OLT alarms
Soak of alarms on a per alarm ID basis
Auditing of all alarms known to the OLT
Setting of alarm thresholds for ONU and OLT alarms
Autonomous alarm reporting
Soak of alarms on a per alarm ID basis
10.1 Viewing Alarms
Unlike the ONU CLI the OLT CLI does not offer any ability to control the alarms manger. Fortunately the Evaluation Kit GUI exposes all of
the underlying functionality.
Observing Alarm Events
Alarm may be observed remotely via the Evaluation Kit GUI, in 4 ways:
The GUI Log Window will display all autonomous alarm messages received from the OLT’s 10/100 craft
port. If alarm auditing is enabled the GUI may also be configured to display messages received based on
the audit.
The appropriate Status Icon will change to a yellow triangle indicating that an alarm is raised.
The Active Alarms panel associated with the alarmed entity will indicate the exact alarm that has been
received from the host interface. This record will be maintained until an event causes the alarm to clear.