SNA8110T Gepon OLT User Manual
陈泽科技有限公司
www.stephen-tele.com
5 OLT Panel
The OLT panel is used to apply settings to OLT attributes. In some cases this may also involve OAM
transactions with ONUs. It should be noted that certain attributes of the OLT such as SLAs are controlled
via the Link Panel.
6 OLT Network Parameters
These commands allow the host to configure the way the PON will be managed.
6.1 OAM Rate
This command is used to view the default OAM rate
6.2 Loopback Timeout Value
This sets the loopback failsafe timer. If the operator sets a port in loopback mode the loopback the OLT will initiate a count down
timer for Loopback Timeout Value ms. When the timer expires the loopback will automatically be canceled.
6.3 MPCP Parameters
6.3.1 Period
The interval at which the OLT will issue a discovery gate.
6.3.2 Window
The discovery window size in bytes.
6.3.3 VLAN Ethertype
This is the Ethertype value that the OLT will use to classify VLAN traffic (default = 0x8100)
7 DBA
The DBA tab allows the user to control virtually every parameter of the TK3721’s highly flexible and efficient Hierarchal Weighted
Round Robin DBA algorithm. The DBA algorithm supplied with the OLT is similar to algorithms found in high performance ATM switches
and is capable of issuing 4 grants every 282 micro seconds, by far the fastest cycle time of any EPON system deployed today. The
TK3721’s DBA can meet 1 ms. Latency requirements for high priority services in a 32 ONU deployment.
7.1 Broadcast SLA