2 FXS Sip/IAX ATA User Guide
陈泽科技有限公司
www.stephen-tele.com
e. Usage
Off hook or press handsfree, Enter the debug mode first, then input the function code and parameter, command follow, after
finishing input, an [##] mark must be inputted to end this configuration. Every segment MUST use ‘*’ to interval the next
segment.
[SAMPLES]
1. Reset to the factory settings:
*#8356#999*1##
2. Set the WAN IP address to 192.168.1.100:
*#8356#100*192*168*1*100*1##
3. Set the WAN IP mode to DHCP:
*#8356#104*1*1##
4. Enable the embedded web server:
*#8356#200*1##
◎
◎
◎
◎
Configure TCP/ IP
The default IP address of the for LAN is 192.168.1.125. And the default Subnet Mask is 255.255.255.0. They can be
changed as you desire. Before configuring by Telnet or WEB mode, you should know the IP setting of and configure the PC
correctly. As an example we use the default values for description.
Connect the local PC to the LAN ports of the with a RJ-45 cable. There are two ways to configure the IP address for
the PC.
a.
Configure the IP address manually. The IP address is 192.168.1.xxx (“xxx” is from 2 to 254), Subnet Mask is 255.255.255.0,
and Gateway is 192.168.1.125 (The ’s default IP address).
b.
Obtain an IP address automatically. Set up the TCP/IP protocol in “Obtain an IP address automatically” mode on your PC.
The built-in DHCP server will assign IP address for the PC.
◎
◎
◎
◎
Configure by Telnet mode
In Terminal type in “telnet [IP address] 2323” and then press
Enter
to access to Telnet mode. About the names and explanations
of parameters refer to
Provisioning Guide for .pdf.
