2 FXS Sip/IAX ATA User Guide
陈泽科技有限公司
www.stephen-tele.com
Chapter 3: Configure the
This chapter provides the method to configure the device. You can configure the by analog telephone, Telnet mode
or WEB browser. Make sure the Telnet or Http embedded is available before configuring (In default setting both Telnet and WEB
mode are open, If you are not sure, you can operate them by analog telephone. Refer to
Configure by Analog Telephone
).
Configuring by provision function refer to
Provisioning Guide for .pdf.
◎
◎
◎
◎
Configure by Analog Telephone
You can configure the device primitively by analog telephone keypad, after the device booting up. All the operations
are invalid before entering the debug mode.
a. Off hook or press handsfree, Press "*#8356#" on keypad in sequence to enter the analog phone debug mode.
b. Functions
100 Set the WAN IP address.
101: Set the WAN subnet mask.
102: Set the WAN default gateway.
103: Set the WAN first DNS server.
104: Set the WAN IP mode.
105: Set the LAN IP address.
106: Set the LAN subnet mask.
200: Enable/Disable embedded web server.
300: Enable/Disable Telnet server.
999: RESET to factory settings.
1
Once the one of 100-103 is set, the WAN IP mode will be set to STATIC mode. For the 104, 0 is STATIC mode, 1 is DHCP mode, 2
is PPPoE mode.
c. Options
0: Disable/Exit/No
1: Enable/OK/Yes.
d. Interval use the sing "*", at the end input "##". (In IP/SUBNET MASK/GATEWAY/DNS mode, use ‘*’ to instead of ‘.’).
