Trouble Shooting
TROUBLE SHOOTING GUIDE:
SYMPTOM CAUSE
SOLUTION
Show E0
Not equip Safety key
Please equip the Safety key
Show E1
Speed feedback equipment err
Please check Speed feedback equipment
and 10-pin cable or contact special service
Show E2
Motor or Motor drive err
Please check PIN cable or contact special
service
Show E3
The error of Speed over limit
Adjust Speed feedback equipment or
contact special service
TROUBLESHOOTING YOUR TREADMILL:
This treadmill is designed to be reliable and easy to use. However, if you experience
a problem, please reference the trouble shooting guide listed below:
PROBLEM: The console does not light up.
SOLUTION: Verify that the power cord is plugged in properly to the outlet, and the
treadmill switch is turned on.
PROBLEM: The treadmill circuit breaker trips during a workout.
SOLUTION: Verify that the treadmill is plugged into a dedicated 20amp circuit.
*Note: No extension cord.
PROBLEM: The treadmill shuts off when elevating.
SOLUTION: Verify that there is enough slack in the power cord to reach to the wall
outlet during elevation.
PROBLEM: The running belt does not stay centre during a workout.
SOLUTION: Verify that the treadmill is on a level surface. Verify that the belt is
properly tightened. (Refer to belt adjustment)
PROBLEM: The treadmill makes a clicking noise towards the front of the machine
while walking or running on it.
SOLUTION: For optimum use, the treadmill needs to be level.
20
