If the belt is still not centre, repeat the above step until the running belt is on
centre.
2. After the belt is centre, increase the speed to 16kph and verify that it is running
smoothly. Repeat the above steps if it is necessary.
If the above procedure is unsuccessful in resolving the off-centre, you may need to
increase the belt tension.
LUBRICATION
The treadmill is factory-lubricated. However, it is recommended to check the lubrication of
the treadmill regularly, to ensure an optimal operation of the treadmill. It is usually not
necessary to lubricate the treadmill in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the
belt, as far as possible. If traces of silicon spray are found, lubrication is not necessary. In
case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
Application of lubricant on the belt
:
Position the belt so that the seam is located in the middle of the plate.
Insert the spray valve in the spray head of the lubricant container.
Lift the belt at one side and hold the spray valve in a distance to the front end of
striding belt and plate. Start at the front end of the belt. Lead the spray valve in
direction of the back end. Repeat this process on the other side of the belt. Spray
each side for about 4 seconds.
Wait 1 minute to let the silicon spray spread, before starting the machine.
CLEANING:
Regular cleaning of the striding belt ensures a long product life.
Warning
: The treadmill must be turned off to avoid electrical shocks. The power
cord must be pulled out of the socket, before starting the cleaning or maintenance.
18
Summary of Contents for CE-7305
Page 1: ...Treadmill Manual...
