INST.No.INE-508-P0
-8-
4.1.1 Installation
Fix the protective case with 6 pieces of M16 bolts to a mounting stand (prepared by you) so
that the protective case is parallel to a measuring area and the center of the protective case is
positioned with the center line of a measuring area.
4.1.2 Housing the detector unit
(1) Perform the distance setting before housing the detector unit in the protective case.
(2) Remove the upper cover of the protective case.
(3) Insert the detector unit until it contacts the bottom of the protective case while sliding the
fixing holes of the detector unit along with the guide supports, and then fix the detector
unit with 2 pieces of M20 bolts. In this case, insert the detector unit keeping it as parallel
as possible.
Be careful that it will have galling if the detector unit is put by force.
(4) Perform connections by drawing the connecting cord through the cable gland.
(5) By mounting the upper cover, the housing of the detector unit is completed.
Protective case
Guide support
Fixing hole
Cable gland
Detector unit
4. Accessories
